Milwaukee 4555-22 Manuel D'utilisateur page 14

CAUTION
Do not run the pump without the water supply con-
nected and turned on as this will result in damage
to the pump.
STARTING AND STOPPING THE PRESSURE
WASHER
See Figures 12 - 15.
NOTE: Before starting the engine, read the engine
operator's manual.
To start:
1. Place the fuel valve lever in the on position.
2. If the engine is cold, move the choke lever to the closed
position. As the engine warms, move the choke to the
open position.
If the engine is warm, leave the choke lever in the open
position.
3. Move the throttle lever away from the MAX position
(pushed to the right) to about one-third of the way
towards the MIN position (pushed to the left).
4. Place the ON / OFF Switch in the ON ( l ) position.
5. Grasp the recoil starter and pull slowly until resistance
is felt. Give the recoil starter a short, brisk pull to start
the engine.
NOTE: If starting is difficult, release the pressure in the
spray wand by pulling the trigger.
6. Move the throttle lever to the MAX position once the
machine is running.
Fig. 12
THROTTLE
LEVER
RECOIL
STARTER
page 14
OPERATION
MAX MIN
To stop:
1. Move the throttle lever to the MIN position.
2. Place the ON / OFF switch in the OFF ( O ) position.
3. Turn the fuel valve lever off.
Fig. 13
SWITCH
Fig. 14
RECOIL
STARTER
Fig. 15
CLOSED
CHOKE
FUEL VALVE
LEVER
OFF
OFF
ON
OPEN
ON