Unito LAVA Mode D'emploi page 21

TECHNICAL SPECIFICATIONS
UNITO LAVA Smart Water System
Dispensing water types :
Ÿ
Ambient water, Cold/Hot tap water.
Boiling capacity:
Ÿ
Heating time:
15 minutes (from 20°C to 100°C at room temperature).
Ÿ
Min./Max. main pressure:
Ÿ
System max. safety pressure:
Ÿ
Max. hot water temperature :
Ÿ
Operation:
Ÿ
Power supply :
Ÿ
Max. power consumption:
Ÿ
Standby power consumption :
Ÿ
Safety features:
Maximum temperature fuse, Safety valve(including
Ÿ
pressure relief valve , a built-in one direction valve & on/off valve).
Dimensions:
Ÿ
Weight:
Total weight: 6.85kg (Faucet: 2.35kg, Empty Boiler: 4.5kg),
Ÿ
Flow rate:
Ÿ
Max. water hardness :
Ÿ
CARE AND MAINTENANCE
Regular maintenance of the UNITO LAVA Smart Water System
is required to prevent damage or downtime. Service should be
performed by qualified and certified personnel only.
Warning: Disconnect the power supply from the UNITO LAVA
Smart Water System before maintaining the unit。
Keep the UNITO LAVA Smart Water System in a dry, clean
Ÿ
space. Minimize exposure to dust. Power button or other
controls should never be wet.
If the unit becomes wet, immediately shut it down. Wait for the
Ÿ
unit to completely dry before turning it on again.
Clean exterior surfaces of the unit with a soft, lint-free cloth.
Ÿ
Never use alcohol, paint thinner, benzene or other solvents to
clean this unit. Never use an abrasive material such as a
brush or scouring pad to clean surfaces.
Always test your cleaning solution on an inconspicuous area
Ÿ
before applying to the entire surface.
Wipe surfaces clean after applying cleaner.
Ÿ
Never expose the unit to vibration.
Ÿ
Make sure that all cabin ventilation outlets are always free
Ÿ
and clear.
In the event of mechanical/power failure or damage, do not
Ÿ
attempt to repair the system unit or wires. Call a certified
technician.
If the UNITO LAVA Smart Water System requires service,
Ÿ
please consult a certified dealer. Unauthorized service may
void the warranty.
Close/open the system valve and safety valve every 6
Ÿ
months.
Clean aerator once a year.
Ÿ
20
Boiling water, Mix hot/cold,
2/5 bar (200/500 kPa).
8 bar (800 kPa).
Operation via Electronic control knob, handle,
220~240VAC, 50~60HZ.
Boiler: 222 x 282 x 396mm,
2.0 L/min(Water pressure is 3 bar ).
TROUBLESHOOTING
Read and follow the assembly instructions. If the UNITO LAVA
Smart Water System is not functioning, please check
troubleshooting table. If the water system is still not working
properly, disconnect power supply and contact authorized
UNITO customer service center for assistance. When calling for
assistance, please provide your product model and serial
4.4 Litres.
number.
Symptom
No water
100°C.
owing, the
water is
owing too
slow
1550 W.
2.3 W.
The water is
sputtering
or is
irregular
10° dH.
No boiling
water
RING LIGHT INDICATION
Possible Cause Solution
- Main water supply valve - Turn on the main water
or safety valve is turned supply valve or safety
off. valve.
- Check whether hoses are
- Hoses are twisted.
twisted.
- Check the water
pressure. It should be
above 2.0 bar. Check a
- There is no or too little different tap. If the
water pressure. pressure is also low there,
check the mains water tap
and contact your water
supplier.
- The boiler is turned off or
not connected to power - Connect to power supply.
supply wall socket.
- Safety valve or main - Turn on the Safety valve
water supply valve is or main water supply
turned off. valve.
- Faulty Safety valve(cut- - Contact UNITO customer
off). service.
- the boilier is not
- Follow page 9 step A to C
activation
Description
Standby mode.
Ambient water mode.
Boiling water mode.
Mix hot/cold
First time activating boiler is not
followed. Repeat the start process as
per step of the instruction(See page 9)
and activate boiler rst time.
System error. First check the cable
connection in the water system, if the
cable connection is good but still
ashes in red, please contact UNITO
customer service.