Electrical Connections; Activating The Remote Control - CAME ZBX74-78 Instructions De Mise En Service

Electrical connections

L-N Power supply 230V (a.c.) 50/60 Hz
10-11 Terminals for powering 24V (a.c.) accessories
W-E1 Flashing light (socket rating: 230V - 25W max.)
W-E1 Cycle lamp: (contact rating: 230V – 60W max.)
Set DIP 1 and 6 switch to ON.
11-FA Open gate indicator-light (socket rating: 24V - 3W max.)
11-FC Close gate indicator-light (socket rating: 24V - 3W max.)
2-C1 Re-open during closing (N.C.) socket
2-C3 Partial stop" (N.C.) socket

Activating the remote control

-Connect the antenna's RG58 cable to the apposite terminals.
-Lock the radiofrequency card into the electronic card
ries).
N.B.: the electronic card only recognises the radiofrequency card when the power is on.
Memorisation
CH1 = Channel for direct command to a function of the the gearmotor's card, ("open only / "open-close-invert" or "open-stop-close-stop"
command, depending on the choice made on DIP switches 2 and 3).
CH2 = Channel for direct command to an auxiliary device or for the control of two paired motors, connected to B1-B2.
A
-Keep the "CH1" button on the electronic card pressed. The LED fl ashes.
-Press the transmitter button you wish to memorise. The LED will stay on to show memorisation has been successful.
-Repeat the procedures for the "CH2" button associating this to another button on the transmitter.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
U-V-W 230V (d.c.) motor
+-E-D Encoder 230V (E=black, D=red)
1-2 Stop button (N.C. socket)
2-3P Keyswitch and/or partial opening button (N.O.)
2-7 Keyswitch and/or commands button (N.O.)
B1-B2 Possible output of the radio receiver's second channel
(N.O.). Socket rating: 5A-24V (d.c.).
Connection of antenna
D
AFTER CUTTING OFF THE POWER SUPPLY (or after disconnecting the batte-
B