Exakt DC-270 Mode D'emploi page 6

 Beware when changing blades as they can become
hot during use. Allow the blade time to cool before
replacing.
Servicing
EXAKT Precision Tools Ltd.
Midmill Business Park
Tumulus Way
Kintore
Inverurie AB51 0TG
Scotland, UK
List of user-replaceable parts:
Blade Part No.
12 TCT
18 TCT
20 TCT A
24 TCT P
Diamond
If the replacement of the supply cord is necessary, this has
to be done by the manufacturer or his service agent in order
to avoid a safety hazard.
Explanation of Symbols
Conforms to
European
directives
Double insulated
appliance
Read instructions
before use
Risk of electric
shock
Risk of injury
when instructions
are not followed
Specifications
Usage
Motor power
Depth of cut
Approx. no load blade speed
Approximate weight
Maximum blade diameter
Maximum / Minimum blade width
Hand arm vibration value loaded
Uncertainty k
Sound pressure level Under load
Sound power level L Under load
wa
Uncertainty k
Tel: +44 (0)1467 633800
Fax: +44 (0)1467 633900
e-mail: info@exaktpt.com
Freephone numbers:
D: 0800 180 7063
F: 0800 916696
I: 800 930 019
Accessory Part No.
Blade washer
Blade screw
Torx screw
Motor brushes
Wear suitable
face mask
Wear eye
protection
Wear ear
protection
Discard at
recognised
collection point
Product reg. No.
WEE/BH0080UV
DC-270
DIY and Trade
500W
0 -26 mm
5500 rpm
2.5 kg
110 mm
1.2 mm / 0.9 mm
2.842 m / s
2
1.5 m / s
2
90 dBA
101 dBA
3 dBA
Cutting Specs.
Wood All types up to 26 mm
Aluminium Up to 12mm
Composites MDF, ply & chipboard to 26 mm
Plastics Tufnol, perspex, fibreglass etc.
Minerals Wall & Floor tiles, slates etc.
Where there is access to cut from the back surface of the
material, over cutting by the allowance shown will ensure
perfect corners on the front surface.
Over cutting allowances in mm
Depth setting 4 6
Overcut by 7 10
Assumes the depth has been set to 5 mm greater than
the material to be cut.
The declared vibration total value has been measured in
accordance with a standard test method and may be used
for comparing one tool with another.
The declared vibration total value may also be used in a
preliminary assessment of exposure
WARNING: The vibration emission during actual use of the
power tool can differ from the declared total value
depending on the ways in which the tool is used.
WARNING: There is a need to identify safety measures to
protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of
all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to
trigger time)
4
9 12 18 22
14 17 22 24.5
 EXAKT Precision Tools Ltd. 2010