Error Messages; Care And Maintenance - Medisana 99397 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Do not attempt to recharge these batteries! There is a danger of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Keep unused batteries in their packaging away from metal objects in order to prevent short
circuiting!
• Do not throw used batteries into the household refuse; put them in a hazardous waste container
or take them to a battery collection point, at the shop where they were purchased!
6 Change the unit of weight
You may have your weight displayed in kilograms (kg), stones (st) or pounds (lb). Press button
the unit you wish is shown.
7 Weighing "Step-on"-function
1. Make sure the scales are on a firm, level surface. If you only want to weigh yourself but have moved
the scales just before, you must first initialise the scales. To do this, press your foot on the middle
of the surface of the scales. "0.0 kg" appears in the display. When the scales switch off, they are
ready for the "step-on" function. This procedure is not necessary if you have not moved the scales.
2. Step onto the scales and stand still. The device switches on automatically and the display
shows "0.0 kg".
3. Your weight is measured, flashes twice and is then finally displayed.
4. Step down from the scales. The display changes to "0.0 kg". The scales switch off automatically
after 10 seconds.

8 Error messages

The following error messages may appear in the display:
The scale is overloaded.
DThe battery is low and must be replaced.
If your personal scales do not function to your satisfaction, check the following before contacting a
service centre.
• Check whether the batteries have been inserted correctly.
• Check whether the correct unit of weight has been selected.
• Check whether the scales are freestanding on a solid and even surface. They must not be touching
a wall or any other object.
• Weigh yourself again.

9 Care and maintenance

Remove the battery before cleaning the unit. Never use aggressive cleaning agents or stiff brushes.
Clean the scale using a soft and lightly moistened cloth. Never use abrasive cleaning agents or alcohol.
Do not allow any water to get into the unit. Do not use the unit again until it is completely dry. Do not
expose the unit to direct sunlight; protect it against dirt and moisture. Do not store the scale in
a vertical position, and remove the batterie from the unit if it will be unused for a longish period.
Otherwise there is a risk that the battery might leak.
ENGLISH
ENGLISH
until
briefly
7

Publicité

Table des Matières
loading

Table des Matières