Sicherheitsvorkehrungen; Mesures De Précaution - Fisher Bioblock Scientific Ismatec Reglo Z Mode D'emploi

Table des Matières

Publicité

4

Sicherheitsvorkehrungen

I
Je nach Material und Druck-
bedingungen haben Schläuche
eine gewisse Gasdurchlässigkeit
und können sich statisch aufladen.
Wir warnen vor möglichen
Gefahren, falls Schläuche in ex-
geschützte Räume verlegt werden.
I
Falls wegen Schlauchbruchs
durch auslaufende Medien Schä-
den verursacht werden können,
sind vor Inbetriebnahme die not-
wendigen Sicherheitsvorkehrun-
gen zu treffen.
Manipulieren Sie nicht am
I
Pumpenkopf, bevor die Pumpe
ausgeschaltet und vom Netz
getrennt ist.
I
Vor der Inbetriebnahme muss
der Pumpenkopf mit der
Pumpflüssigkeit oder Wasser
gefüllt werden. Der Pumpenkopf
darf nicht trocken laufen.
Safety precautions
I
The permeability of pump-tubing
depends on the material used and
pressure conditions. Tubing can
also become electro-statically
charged. Please be aware of
possible hazards when laying
tubing in explosion-proof
chambers.
I
Tubing can tear and burst during
operation. If this could cause
damage, the necessary safety
measures based on the specific
situation must be taken.
I
Do not manipulate the pump-head
before the pump is switched off
and disconnected from the mains.
I
Before initial start-up, the pump-
head must be filled with the
pumping liquid or water. Never run
the pump-head under dry
conditions.
Mesures de précaution
I
La perméabilité des tubes dépend
des matériaux utilisés et des
conditions de pression. Les tubes
peuvent également se charger
d'électricité statique. Soyez bien
conscients des risques inhérents à
l'installation de tubes dans des
locaux protégés contre les
explosions.
I
En cours d'exploitation, les tubes
peuvent se déchirer ou même
éclater. Si cela pouvait causer des
dommages, il faut prendre les
mesures de sécurité adaptées à la
situation spécifique.
Ne manipulez jamais la tête de
I
pompe avant que la pompe n'ait
été mise hors service et
déconnectée du réseau électrique.
I
Avant la mise en service, remplir la
tête de pompe d'eau ou du liquide
à pomper. La tête de pompe ne
doit jamais fonctionner à sec.
ISMATEC SA/REGLO-Z/-ZS/24.04.02/CB/GB

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ismatec reglo zs

Table des Matières