Care And Cleaning - Welch Allyn Braun ThermoScan PRO 4000 Mode D'emploi

Connecting
Connect the station with the mains only via the low
voltage adapter. The green connection indicator will
light up, showing that the station is ready for use.
Charging
When the PRO 4000 Thermometer is not in use it
should be stored – in its protective cover – in the
Base Station. When placed into the station, the
thermometer will give a short beep and the yellow
charging indicator will light up.
The yellow light indicates that the thermometer's
batteries are charging. When the batteries are fully
charged, the yellow light will go out. If it comes on
again later on, this indicates that the batteries are
being recharged to maintain their full capacity.
When in use, the thermometer's display may show
«RET» and the battery symbol. This means it has to
be returned to the station for charging.

Care and Cleaning

Disconnect the Base Station from electrical outlet.
Use a soft, dry cloth to clean the Base Station. Do not
use abrasive cleaners. Never submerge this device in
water or any other liquid. Store in a dry location free
from dust and contamination and away from direct
sunlight.
Anti-theft function
The PRO 4000 Thermometer is equipped with an
anti-theft function which requires returning the ther-
mometer to the Base Station within a pre-selected
time. If this time is exceeded, the thermometer will
be locked.
When leaving the factory, the anti-theft function of
the PRO 4000 is turned off. Below are details to set
the function and time period:
• Put the thermometer into the station and wait for
the long confirmation beep.
• Press the start-button on top of the thermo-
meter and keep it pressed while you take the
thermometer out of the station.
7