Neato Robotics botvac D7 connected Guide D'utilisateur page 3

Connecting Your Robot
1
REMOVE FILMS AND STICKERS
IMPORTANT: Remove all protective films and shipping material from
the robot and charge base. If they are not removed, your Neato robot
will not operate correctly.
2
SET UP CHARGE BASE
Plug the power cord
securely into the
charge base.
Adjust the length of
the cord by wrapping it as shown.
Choose a wall outlet that has a 3' (1 m)
clearance on both sides and in front
of the charge base. This helps your
robot find the charge base.
Plug in the power cord and push
the charge base against the wall.
TIP: Locate the charge base on a hard floor surface.
TIP:
Make sure the power outlet is not controlled by a switch.
3
INITIAL ROBOT CHARGING
Place the rounded side
of your Neato robot
against the metal
charging contacts on
the charge base until
the contacts are
pushed all of the way in.
For best results, charge the robot fully before your first cleaning
cycle to experience a full high performance cleaning.
NOTE: During bootup, the robot LEDs next to the Start Button will
alternately blink blue
NOTE: Your robot is only compatible with the included charge base.
4
Get your • Smartphone / Tablet
• 2.4 GHz or 5 GHz Wi-Fi name & password
5 Download the Neato app
6
Open the Neato app and create a Neato account
7
Click Link in email to verify your email address
8
Follow steps in the Neato app to CONNECT YOUR ROBOT
Charging Contacts