Returning For Service - DeFelsko PosiTector SHD Mode D'emploi

Returning for Service

Returning for Service
Before returning the Gage for service...
1.Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2.Examine the indentor tip and presser foot for dirt or damage.
3.Perform a Hard Reset. (pg. 5)
4.Attempt a measurement on the supplied test block.
(see Verification, pg. 3)
5. If issue is not resolved, Update your PosiTector gage body
(pg. 9) and re-attempt measurements.
IMPORTANT:
If you must return the Gage for service, describe the problem
fully and include measurement results, if any. Be sure to also
include the probe, your company name, company contact,
telephone number and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTector and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and
in other countries. Other brand or product names are trademarks or registered trademarks of their
respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.
and Limited Liability
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2019
All Rights Reserved
10