Operation - Carrera CRR MATCH-15 Mode D'emploi

1. Connect the wall power supply to the device.
2. Insert the wall power supply into an easily accessible
socket. the LED lights up. It stays lit as long as the device
is connected to the mains.
3. Put the device down with the front upwards.
4. After the wall power supply is disconnected, the LED goes
off. With a completely charged battery pack, the device is
able to operate for approx. 45 minutes.

6. OPeRatION

regardless of the charging state of the battery pack, you are
always able to use the hair trimmer with the power pack.
1. In order to use the power pack, ensure that the device is
switched off.
2. Connect the wall power supply to the hair trimmer.
3. Insert the wall power supply into an easily accessible
socket.
4. Use the on/off switch on the side to switch on the hair trimmer.
Replacing/adjusting the comb attachments
waRNING! Switch off the device before replacing or chang-
ing the comb attachments.
Push on the comb attachment by carefully inserting
Q
the guide arms of the comb attachment into the lateral
recesses of the device until it locks into place.
Set the cutting length: use the control dial on the upper
Q
side of the device to set the desired position of the comb
attachment. the device must be switched off during this
adjustment.
to remove the comb attachment, first switch off the device
Q
and then grasp the attachment by holding the two guide
arms with your thumb and pointer finger, and pull it out
off the lateral recesses.
32