Carrera CRR MATCH-15 Mode D'emploi page 29

DaNGeR of electric shock
Do not operate the device if the device, the wall power
supply or the cable shows visible signs of damage or if
the device has been dropped.
Connect the cable to the device before plugging the
Q
wall power supply into a socket.
Only connect the wall power supply to a properly
Q
installed easy to access socket which supplies voltage
matching the rating plate. the socket must still be eas-
ily accessible after connection.
Ensure that the cable cannot be damaged by sharp
Q
edges or hot surfaces.
Ensure that the cable is not trapped or crushed.
Q
Always pull at the wall power supply and never pull on
Q
the cable when unplugging the wall power supply.
remove the wall power supply from the socket ...
Q
... after each use,
... after each charging process,
... if a fault occurs,
... before cleaning the device and
... during thunderstorms.
to avoid any risk, do not make any changes to the de-
Q
vice or accessories. Do not replace the cable yourself
either. repairs should only be carried out by a special-
ist or our Service Centre (→ 13. Warranty and Service).
29