Dometic PERFECTVIEW M 55LX AHD Instructions De Montage Et De Service page 20

Using the LCD monitor
8.5 Setting the automatic search
Proceed as follows to set the automatic search (fig. 0, page 6):
➤ Press the "
" button (5) until the "Auto search" menu appears.
➤ Press the "+" button (3) to switch on the automatic search.
✓ The monitor starts the cameras in the order "Camera 1 – Camera 2 – Camera 3 – Camera 4"
automatically in the preset time.
After the first run through, only the inputs with connected cameras are shown.
No sound is available in this operating mode.
Setting the display time
You can set the display time from 2 to 20 seconds.
➤ Press the "
" button (5) until the "Cam Delay" menu appears.
➤ Press the "+" button (3) to increase the camera display time.
Press the "–" button (4) to reduce the camera display time.
Quitting the automatic search
➤ Press the "
" button (5) until the "Auto search" menu appears.
➤ Press the "+" button (3) to switch off the automatic search.
8.6 Detecting the trailer camera
This function is required when using a trailer camera (fig. c, page 7) if the system is activated
automatically via the reverse gear. To initialise the automatic detection switch off ignition once after
setting.
•
One camera connected (e.g. towing vehicle without a trailer):
the camera connected to CAM1 (1) is activated.
•
Two cameras connected (e.g. towing vehicle with a trailer):
the camera connected to CAM4 (2) is activated (CAM1 is inactive).
8.7 Setting the distance markers
To set the distance markers, proceed as follows (fig. 0, page 6):
➤ Press the "
" button (5) until the "Scale" menu appears.
✓ The distance markers to be set appear.
➤ Press the "+" button (3) to move the red highlighted distance markers.
➤ Press the "–" button (4) to select the next distance marker.
➤ Press the "
" button (5) to exit the settings.
20
M55LX AHD, M75LX AHD
EN