Cleaning And Maintenance - AEG SR 4360 BT Mode D'emploi

Guitar socket
It is possible to connect an E-guitar to this device. (Not
included in the delivery scope)
1. Connect your E-guitar to the GUITAR socket (16).
⊝
⊕
2. Use the G.VOL buttons (14) to adjust the guitar
volume.
NOTE:
You may also use the remote control to adjust the guitar
volume.
1. Press the VOL MODE button (3) until "GUI VOL" ap-
pears in the display.
2. Then use the VOL buttons to adjust the guitar
volume.
Microphone socket
It is possible to connect a microphone to this device. (Not
included in the delivery scope)
1. Connect your microphone to the MIC socket (18).
⊝
⊕
2. Use the M.VOL buttons (20) to adjust the micro-
phone volume.
CAUTION:
In order to prevent acoustic feedback (sharp whistling
sound), use the microphone outside the speaker' s radiation
zone.
NOTE:
You may also use the remote control to adjust the micro-
phone volume.
1. Press the VOL MODE button (3) until "MIC VOL" ap-
pears in the display.
2. Then use the VOL buttons to adjust the micro-
phone volume.

Cleaning and Maintenance

WARNING:
Do not immerse the device in water.
• Always remove the mains plug before cleaning the
machine.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
Troubleshooting
Symptoms Course
CD can not be CD is not inserted
played back. or inserted incor-
rectly.
Batteries too weak. Insert new batteries
CD jumps dur- Check the disc for
ing playback. fingerprints, dirt or
scratches.
Device cannot Device crashes and
be operated. "hangs".
No audio The device is not
signal during registered with the
bluetooth con- audio source.
nection.
Volume too low.
Device can not Registration does
be connected. not work.
Audio source is
shut off.
Bluetooth is shut
off on the audio
source.
Bluetooth version
is not supported.
Sharp whistling Acoustic feedback. Use the microphone
sound during
microphone
use.
English
51
Solution
Ensure that the disc is
inserted with the label
facing upwards.
or operate the device
with the mains lead.
Check the disc for
fingerprints, dirt or
scratches.
Disconnect the power
supply for 5 sec. Then
switch the device on
again.
Ensure that there is a
connection. Register
the device with the
audio source again, if
necessary.
Increase the volume
on the device.
Increase the volume
on the audio source.
Check to see if the
audio source supports
the A2DP protocol.
Turn on the audio
source.
Turn on the Bluetooth
function on the audio
source.
Use a different play-
back device.
outside the speaker' s
radiation zone.