Protecting The Environment; Ec Declaration Of Conformity - Black & Decker BES720 Mode D'emploi

ENGLISH
Switch on the saw.
u
Place your hands (with fingers closed) flat on the
u
workpiece and push the workpiece along and into the
blade (4).
Guide at the side with your left or right hand (depending
u
on the position) only as far as the front edge of the saw
blade guard (2).
Always push the workpiece through to the end of the riving
u
knife (3) using the push stick (19) as shown in figure N.
The offcut piece remains on the saw table (1).
u
Secure long workpiece against falling off at the end of the
u
cut ) with a roller stand etc.
Warning!
Always use the push stick (19) when ripping small
workpieces.
Do not cut excessively small workpieces.
Cross Cutting
Lock the miter gauge (6) at 0 degree
u
Set the bevel angle to 0 degree
u
Adjust the saw blade (4) height
u
Hold the workpiece flat on the table (1) and against the
u
fence. Keep the workpiece away from the blade.
Keep both hands away from the path of the saw blade.
u
Switch the machine on and allow the saw blade to reach
u
full speed.
Hold the workpiece tightly against the fence and slowly
u
move the workpiece together with the fence assembly until
the workpiece comes underneath the upper blade guard.
Allow the teeth to cut, and do not force the workpiece
u
through the saw blade. The saw blade speed should be
kept constant.
After completing the cut, switch the machine off, allow the saw
blade to stop and remove the workpiece.
Warning! Never push or hold the cut-off-side of the work-
piece.
Blade jamming handling
Ensure the machine is disconnected from the power
u
source.
Remove the workpiece. Be careful of your hands not
u
touching the saw blade.
Press the overloaded protector (21) and connect the plug
u
again, the machine can resume working.
After use
After use, wipe off chips and dust adhering to the tool with
u
a cloth or the like.
Lubricate the sliding portions with machine oil to prevent
u
rust.
12
(Original instructions)
Z

Protecting the environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
Voltage
Frequency
Power input
No-load speed
Blade diameter
Blade body thickness
Allowed range of kerf width
Bore size
Riving knife thickness
Max. cutting depth at 45º
Max. cutting depth at 90º
Blade bevel range
weight
Level of sound pressure according to EN 62841:
L (sound pressure) 95 dB(A), Uncertainty (K) 3 dB(A)
pA
L (sound power) 108 dB(A), Uncertainty (K) 3 dB(A)
WA
%

EC declaration of conformity

MACHINERY DIRECTIVE
BES720 Table Saw
Black & Decker declares that these products described under
"technical data" are in compliance with:
EN62841-1:2015, EN62841-3-1:2014+A11:2017,
These products also comply with Directive
2006/42/EC, 2014/30/EU and 2011/65/EU.
For more information, please contact Black & Decker at the
following address or refer to the back of the manual.
BES720 Type 1
V 230
Hz
W 1800
/min 5200
mm 254
mm 2.0
mm 2.8
mm
mm 2.5
mm
mm
0 - 45º
kg 27.56
50
30
58
80