Removing / Replacing - Duco Actuatorprint Manuel D'utilisation

Pairing as a feed-through component
Activate 'Installer mode' by tapping 'INST' on the 'master'. The
1
LED will flash green rapidly.
Tap once on the Actuatorprint button. The LED rapidly flashes
2
red until the Actuatorprint has been added to the network and will
slowly flash green. Tap the Actuatorprint button again in order to
add underlying components. The LED will flash green rapidly.
Add all underlying components in this zone by tapping once on
3
them.
Exit the zone by tapping the Actuatorprint button once again. The
4
LED on the Actuatorprint will revert to flashing green slowly rather
than rapidly.
Exit 'Installer mode' by tapping 'INST' on the master.
5
4B.

Removing / replacing

'Installer mode' needs to be activated in order to remove the Actua-
torprint from the network or to replace it. This can be done by tapping
'INST' on the master or by pressing the Actuatorprint button for 5
seconds until the LED flashes green slowly.
ENGLISH
31