Cabling; Pwm / 0-10 V Control; 2/3-Point Control - Duco Actuatorprint Manuel D'utilisation

ENGLISH
3

Cabling

3A.
The Actuatorprint is supplied as standard with PWM. It is also available
upon request with 0-10 V instead of PWM.
A PWM or 0-10 V signal is used to drive the actuator from 0% (closed)
to 100% (open), depending on the ventilation position.
3B.
With 2 or 3-point control, the actuator is opened or closed by transmit-
ting a 24 VDC signal to the actuator for a set time.
The direction, opening or closing, is determined by the direction of flow
of the control signal (Y). See illustrations below.
28
PWM / 0-10 V control

2/3-point control