Recharging - DJO Global Compex WIRELESS Manuel De L'utilisateur

PAUSE MODE
You can pause the device by pressing the centre button or the
On/Off button on one of the modules during the stimulation.
Please note: The session will resume at 80 % of the energy levels
that were being used prior to the interruption.
EN

5 RECHARGING

BATTERY LEVEL
The battery level of each module is shown when you switch them on before starting your stimulation session. The battery level of the remote
is always visible in the upper right corner. The little green circles indicate how many modules are switched on and can be detected by the
remote control.
CONNECT THE DOCKING STATION
Connect the AC adaptor supplied with your device to the docking station then plug it into a socket. Compex strongly advises you to fully
charge the remote and module batteries before using them for the first time as this will improve their performance and life span.
CHARGING THE MODULES AND THE REMOTE CONTROL
At the end of your stimulation session, it is highly recommended
that you store the remote control and the modules in the docking
station in order to recharge them.
User Manual
Resume the stimulation session
Back to the screen displayed before the
stimulation session
Remote control battery level
Number of modules which are on
and detected by the remote control
Module battery level
END OF SESSION
At the end of the session, a screen with a check mark comes up. Press
any button to return to the main menu. To switch off the device, just
press and hold the On/Off button on the remote control for more
than 2 seconds. This will also switch off all the modules.
14