Gree D Série Guide D'utilisation page 20

(1) Temperature View
The function is for checking temperature at various temperature points. Select Temp. View and
press the Confirm button to go to the pages as shown in the following drawings.
Press the Up or Down selection button to convert among the above four pages. Press the Exit
button to quit the menu page and go back to the previous menu.
When page 1 is present on the screen, press the Reset button and the Exit button
simultaneously for 3 seconds, and C Water Tin and H Water Tin, as displayed previously, will be
converted to C AVER.Tin and H AVER.Tin. And press again the Reset button and the Exit button
simultaneously for 3 seconds, and C Water Tin and H Water Tin will be displayed again. As such,
display can be converted between water inlet temperature and water inlet average temperature.
Note: above temperature display is dependent on unit model. If the temperature
sensor is not existent for a certain model, "NA" would be present on the display zone for
corresponding temperature point.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
D Series Modular Air-cooled Scroll Chillers Owner's Manual
C Water Tin
C Water Tout
H Water Tin
H Water Tout
Page 1
Page 2
Suction T1
Suction T2
Exhaust T1
Exhaust T2
Page 3
Throttle T1
Throttle T2
Page 4
16
XXX.X℃
XXX.X℃
XXX.X℃
XXX.X℃
XXX.X℃
▲
XXX.X℃
XXX.X℃
XXX.X℃
XXX.X℃
▲
XXX.X℃