Hilti SF 6H-A22 Mode D'emploi page 12

3.3 Items supplied
Drill / driver, side handle, operating instructions.
You can find other system products approved for your product at your local
Hilti Center or online at: www.hilti.com
3.4 Li-ion battery state of charge display
The Li-ion battery state of charge and malfunctions of the power tool are
indicated by the display on the Li­ion battery. The Li­ion battery state of
charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is
ready for use.
1 LED blinks, the power tool is not
ready for use.
4 LEDs blink, the power tool is not
ready for use.
Note
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
If the battery charge state LEDs blink, please refer to the information
given in the Troubleshooting section.
3.5 Indication of overloading and overheating
The power tool is equipped with an electronic system to protect against
overloading and overheating. The power tool switches itself off automatically
in the event of overloading or overheating. After releasing the control switch,
the power tool may not restart immediately when the switch is pressed again
(while the power tool is cooling down).
4 Technical data
4.1 Drill/driver
Rated voltage
Weight
Printed: 01.02.2017 | Doc-Nr: PUB / 5329068 / 000 / 00
Meaning
• Charge state: 75 % to 100 %
• Charge state: 50 % to 75 %
• Charge state: 25 % to 50 %
• Charge state: 10 % to 25 %
• Charge state: < 10 %
• The battery has overheated.
• The power tool has overheated or
is overloaded.
SF 6H-A22
21.6 V
DC
4.4 lb
(2.0 kg)
English 7