EHEIM compactON 2100 Notice D'utilisation page 21

English
5. Operation
CAUTION! Material damage.
The pump must not run dry.
Switching the pump on/off
1. Inside the aquarium: Attach the device below water level at the bottom or the inside of your aquarium (⌦F). Pay attention
to the maximum pond depth (see Technical data).
Outside the aquarium: Attach the device to a stable surface outside of your aquarium (⌦G).
2. Insert the mains plug in the mains socket. Attention: The pump starts immediately!
3. To turn it off, remove the mains plug from the mains socket.
Controlling the flow rate
1. Turn the power controller to adjust the water flow rate (⌦H).
6. Maintenance
DANGER! Electrocution!
▶ All devices must be disconnected from the power supply before any maintenance work is carried out.
CAUTION! Material damage.
▶ Do not use hard objects or aggressive cleaning agents for cleaning.
▶ The appliance components are not dishwasher-proof. Do not clean the appliance or appliance parts in the dishwasher.
The following sections describe maintenance work necessary for optimum and fault-free operation. Regular maintenance
prolongs the service life and assures functionality of the appliance over a long period.
Cleaning the pump
1. Remove the pump from the aquarium.
2. Loosen and remove the two lateral fastening screws a (⌦C).
3. Pull the pump cover b out of the engine body from the front.
4. Pull the impeller e out of the engine body (⌦I).
5. Clean all components under running water.
6. Install the pump again in reverse order.
21