Olympus PPO-E05 Mode D'emploi page 12

2. Mounting the PPO-E05 on the Waterproof Case
This section describes how to mount this product on the PT-E series case. Before mounting, check that
no foreign matter is attached to the O-rings, the port mount thread on the PT-E series case, or the O-
ring contact surfaces. Apply a thin layer of the provided silicone O-ring grease.
Grease applying surface on O-rings
En
Screw in until there
EN 3
Threaded section
O-ring
is no gap.
O-ring contact surfaces
Port mount thread
1 Align the threaded section of the PPO-E05 with the port mount
thread on the PT-E series case.
2 Hold the PT-E series case firmly with one hand, hold the main
body of the PPO-E05 with your other hand and screw it into the
PT-E series by turning the PPO-E05 clockwise.
3 Resistance increases as the PPO- E05 is screwed in more
deeply. However, be sure to screw it in all the way until there
is no gap visible below the threaded section of the PPO-E05.