Standard Accessories; Battery Removal/Installation; Optional Accessories (Sold Separately); Applications - Hitachi Koki DN 12DY Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains
the accessories listed in the table below.
1 Plus driver bit (No. 2) ............................................. 1
2 Charger (UC14YFA) ................................................... 1
3 Plastic case ................................................................. 1
4 Battery ............................................................... 1 or 2
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES (sold separately)

Battery (EB1220BL, EB1226HL, EB1230HL)
Optional accessories are subject to change without
notice.

APPLICATIONS

Driving and removing of wood screws, tapping
screws, etc.
Drilling of various metals.
Drilling of various woods.
Table 1
Before
Blinks
charging
(RED)
While
Lights
charging
(RED)
Charging
Blinks
complete
(RED)
Charging
Flickers
impossible
(RED)
Charging
Lights
(GREEN)
impossible

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the Angle Drill, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle
When the power cord is connected, the charger's
pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger
Insert the battery firmly, in the direction shown in
Fig. 3, until it contacts the bottom of the charger
compartment.
CAUTION
If the batteries are inserted the wrong way, not only
won't they recharge, but they may damage the
charger by blowing the fuse or deforming the
terminals.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red (At 1-second intervals) (See
Table 1).
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Lights continuously
English
Malfunction in the bat-
tery or the charger.
The battery temperature is
high, making recharging
impossible.
6

Publicité

Table des Matières
loading

Table des Matières