Problem Identification - Stiga 95 Combi EL QF Mode D'emploi

Intervention
Safety checks/check controls
General cleaning and inspection
Check the condition of the cutting-means
Check the condition of the transmission belt

14. PROBLEM IDENTIFICATION

PROBLEM
1. Unusual vibrations
while working
2. Uneven cut
3. The cutting means do
not engage or do not
stop promptly when
they are disengaged
If problems persist after having performed the above operations, contact your dealer.
PROBABLE CAUSE
Loose parts or damaged
cutting means.
Cutting-means assembly is full of grass Clean the cutting-means assembly
Inefficient cutting-means
Forward speed too high
compared to height of grass
Problems with the clutch system or
cutting-means transmission belt
Frequency
First time
- Before each use
-
- Before each use
5 hours
Tighten all fastening devices. Have
the damaged parts replaced c/o
an authorised service centre.
Contact your dealer
Reduce the forward speed and/or
raise the cutting height (par. 5.1)
Wait for the grass to dry
Contact the authorised service centre.
EN - 10
And then
after every
After each use
25 hours
SOLUTION
Paragraph
6.2
7.4
8.1
8.2