Alpina PLUG-IN-LIGHT II Mode D'emploi page 7

using the light for the first time you have to remove the security
film with the word "PULL" marked in red. The film is there to ensure
that the battery is fully charged on delivery. This film can simply be
pulled out. The light is switched on and off by pressing on the push
switch and offers a number of different functions (figs. 2–5). Press
once to turn the light on; the red light is lit continuously. Press twice
to put the light into flash mode. Press a third time to deactivate
the light. Please note that the battery of the LED rear light can fail
or become drained. You should therefore check regularly that the
light is working. Parents should also ensure that their children
regularly check the functionality of their LED rear light. The LED rear
light is not a toy and should not be used by children except under
the supervision of an adult. Symbols shown on the product: You
will see a number of symbols on the product (figs. 10–14). Fig. 10:
Declaration of conformity: products labelled with this symbol meet
the requirements of the CE Marking Directives. Fig. 11: Dustbin: the
product must not be disposed of as household waste; it should be
taken to a local collection point or recycling centre. Fig. 12: Indicates
the type of protection against penetration of solids and liquids. Fig.
13: Indication of battery type and voltage. Fig. 14: Indication of Class
3 protection for low-voltage electrical appliances. Changing and
disposing of batteries: To change the battery, first undo both screws
located at the rear of the light (fig. 6). Now follow the steps shown
in figs. 7 to 9 for removing the battery. Remove the rear section of
the casing to access the circuit board. Remove the circuit board
(fig. 7). The battery is located on the reverse side of the circuit
board (figs. 8–9). You can now slide it out. Only use replacement
batteries of type CR 2032 3V (fig. 13). This battery is commonly
available and can be purchased from any good electrical appliance
store. Please note that the battery must only be replaced with a
battery of the same type and voltage. To insert the new battery go
back in reverse order through the steps for removal. Notes: Battery