Initial Power-Up - HEIDENHAIN ND 1202T TOOL-CHEK Guide D'installation

ND 1202T TOOL-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de

8. Initial power-up

To power-up the product:
Press the On (supply) side of the power switch to power-up the product. The startup
X X
screen is displayed.
9. Maintenance
The maintenance procedures described in these instructions may be required
during installation of the product. For additional maintenance information, refer to
the ND 1202T TOOL-CHEK Operating Instructions.
Cleaning
Warning! Risk of electrical shock
While cleaning it is possible to conduct electricity from hazardous live parts if
liquid enters the product.
To avoid the hazard, always power off the product, disconnect the power cable
and never use a cloth that is dripping or saturated with water.
Notice
Never use abrasive cleaners, strong detergents or solvents to avoid damage to
the product.
To clean:
Verify that the power switch is in the off position
X X
Disconnect the power cable from the source of power
X X
Wipe exterior surfaces with a cloth dampened with water and a mild household
X X
detergent
17