Initial Power-Up - HEIDENHAIN ND 1300 QUADRA-CHEK Instructions De Montage

ND 1300 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de

8. Initial power-up

To power-up the product:
Press the On (supply) side of the power switch to power-up the product. The startup
X X
screen is displayed.
9. Maintenance
The maintenance procedures described in these instructions may be required
during installation of the product. For additional maintenance information, refer to
the ND 1300 QUADRA-CHEK Operating Instructions.
Cleaning
Warning! Risk of electrical shock
While cleaning it is possible to conduct electricity from hazardous live parts if
liquid enters the product.
To avoid the hazard, always power off the product, disconnect the power cable
and never use a cloth that is dripping or saturated with water.
Notice
Never use abrasive cleaners, strong detergents or solvents to avoid damage to
the product.
To clean:
Verify that the power switch is in the off position
X X
Disconnect the power cable from the source of power
X X
Wipe exterior surfaces with a cloth dampened with water and a mild household
X X
detergent
Replacing a fuse
Warning! Risk of electrical shock
When replacing a fuse it is possible to touch hazardous live parts.
To avoid the hazard, always power off the unit and disconnect the power cable.
Notice
Use only replacement fuses meeting rated specifications to avoid damage to
the product.
To replace a fuse:
Verify that the power switch is in the off position
X X
Disconnect the power cable from the source of power
X X
Use a small straight slot screwdriver to disengage the locking tabs on the fuse holder
X X
Remove the fuse holder and remove the blown fuse
X X
Insert the new fuse into the fuse holder
X X
Re-insert the fuse holder and push in until the locking tabs re-engage
X X
18
4
Fuse holder and fuses