Table des Matières
Publicité
• Slide the battery into the battery bay on the
bottom of the Quadrocopter.
• Connect the battery in the model.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter flash.
• Switch on the controller at the ON/OFF
switch. Be sure to check the Beginner-Ad-
vanced switch (
13b
stick, i.e. the throttle lever, right to the top,
then fully downwards into the zero position.
• Allow the Quadrocopter a few moments un-
til the system is correctly initialised and is
ready for operation. The LED in the Quadro-
copter now lights continuously. The LED on
the controller now lights continuously.
• Repeat the above points as required, if you
wish to fly more Quadrocopters at the same
time.
• Important note! Please perform the au-
to-trimming
before each flight without
14
fail!
• Check the control system.
• Make yourself familiar with the control system.
• Trim the Quadrocopter as necessary
as described under
when hovering it no longer moves from
the spot without a command from the
controller.
• The Quadrocopter is now ready to be flown.
• If the Quadrocopter displays no functions,
retry the above binding procedure.
• Fly the model.
• Land the model.
• Disconnect the battery plug connection.
• Always switch off the remote control last.
Flying the 4-channel Quadrocopter
NOTE!
Take care particularly in the first few
flights to move the lever on the control-
ler very gently and not over-hurriedly. As
a rule, only very small movements of the
respective levers are necessary to carry
out the desired control commands!
2b
). Push the left-hand joy-
, so that
14
15 16 17
If you notice that the Quadrocopter moves
forwards or to the side without your touching
the respective lever, please adjust the trim of
the Quadrocopter as described in
+/- Gas (up / down)
9
To start or to fly higher, push the gas le-
ver on the left cautiously forwards. To land
or fly lower, push the gas lever on the left
cautiously backwards.
10
To make the Quadrocopter circle to the left
or the right on the spot, move the lever on
the left cautiously to the left or the right.
11
To fly the Quadrocopter to the left or the
right, push the lever on the right cautiously
to the left or the right.
12
To fly the Quadrocopter forwards or back-
wards, push the lever on the right cautious-
ly forwards or backwards.
Looping function
WARNING!
ONLY FOR EXPERIENCED PILOTS!
13 a
Before you do this, make sure you have
ample room on all sides (about 4 m – 13').
180° Loop
When you press the looping button
1x, an audible signal sounds until you
move the right-hand joystick either up or
down, or right or left. The Quadrocopter
then performs the 180° loop or roll in the
respective direction.
The controller in 180° mode is identical
to the controller in normal mode. Should
you wish to return to normal mode, please
press the 'Looping Button'
3-D looping
Press the 'Looping Button'
ond and a rapid signal tone will sound until
you move the right-hand joystick up, down
or to left or right.
The Quadrocopter will then perform the
3-D looping (360°) or a roll in the respec-
tive direction.
19
ENGLISH
14
15 16 17
once more.
1
for 1 sec-
1
.
1
Publicité
Table des Matières
