Table des Matières
Publicité
Note: If the battery voltage/output is low you
will recognise that a considerable trim and/
or controlling is necessary to avoid that the
Quadrocopter starts trundling. This usually
occurs before reaching a battery voltage of
3 V and it is a good moment to end the flight.
Instruction Manual
Contents of package
1
1 x Quadrocopter
1 x Controller
1 x USB charging cable
1x Rechargeable Battery
1 x Set of replacement parts
2 x 1.5 V Mignon AA batteries
(non-rechargeable)
Recharging the LiPo rechargeable
battery
Make sure you only charge the LiPo recharge-
able battery supplied with the LiPo charging
unit also supplied (USB cable and remote
control). If you try to charge the rechargeable
battery with a different LiPo battery charger
or any other battery charger, this might cause
serious damage. Please carefully read the
previous chapter with warnings and guide-
lines on the usage of rechargeable batteries
before proceeding. Supply terminals are not
to be short-circuited.
You can charge the rechargeable battery fit-
ted in the Quadrocopter with its USB charging
cable from a USB port on a computer:
2a
Charging via computer:
• Rechargeable batteries are to be re-
moved from the model before being
charged.
• Connect the USB charging cable with the
USB port of a computer. The LED on the
USB charger cable lights green indicating
that the charger unit is correctly connected
to the computer. If you plug in a Quadro-
copter with a discharged battery, the LED
on the USB charging cable no longer lights
up, showing that the Quadrocopter battery
is being charged. The USB charging cable
and the charging socket on the Quadro-
copter are designed to make incorrect con-
nection impossible.
• It takes about 60 minutes to recharge a
discharged battery (but NOT a deep-dis-
charged one). When the battery is fully
charged, the LED display on the USB
charger cable lights up green again.
Note: when supplied, the lipo-battery is al-
ready partially charged. So the first charg-
ing cycle may well take less time.
It is essential to follow the connection se-
quence given above!
Undo the plugged connection on the
Quadrocopter when you are not using the
Quadrocopter. Failure to observe this pre-
caution may cause battery damage!
2b
Insertion of the rechargeable batteries
into the Quadrocopter
• Push the battery into the compartment and
plug it into the socket there.
After use: Undo the plugged connection
on the Quadrocopter when you are not us-
ing the Quadrocopter. Failure to observe
this precaution may cause battery damage!
Inserting the batteries in the
remote control
3
Open the battery compartment with a screw-
driver and insert the batteries in the remote
control. Please keep in mind the correct po-
larity. Different types of batteries or new and
used batteries are not to be mixed. After
having closed the compartment you can
check all functions of the remote control with
the help of the power-switch on the front.
With the power switch turned ON and
functioning correctly, the top centre LED
on the remote control will light up red. If
the LED control flashes slowly and an
acoustic signal is heard, the batteries in
the controller must be changed.
17
ENGLISH
Publicité
Table des Matières
