Uline H-1030 Mode D'emploi page 8

driVer replaceMent
1. Disconnect the air supply.
2. loosen screw and nut with a 8mm spanner wrench
and a 4mm Allen wrench. (see Figure 15)
3. Remove the magazine assembly. (see Figure 16)
4. loosen the set screw with a 3mm Allen wrench to
unlock the adjusting rod.
Figure 15
Figure 17
Figure 19
PAGE 8 OF 20
operating instructions continued
5. slide the linkage mechanism and adjusting rod
simultaneously from the collar. (see Figure 17)
6. loosen the screws with a 3mm Allen wrench.
(see Figure 18)
7. take off the spring pin with a hammer and 6mm
straight rod. (see Figure 19)
Magazine Assembly
Figure 16
Figure 18
0514 IH-1030