Uline H-1030 Mode D'emploi page 10

piston replaceMent
1. Remove screws and nut with 8mm spanner wrench
and 4 mm Allen wrench. (see Figure 24)
2. Remove magazine assembly. (see Figure 25)
3. loosen set screw with a 3mm Allen wrench to unlock
the adjusting rod.
4. slide linkage mechanism and adjusting rod
simultaneously from collar.
5. loosen collar with a 3mm straight rod to remove the
spring. (see Figure 26)
Figure 24
cap
Figure 27
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 10 OF 20
operating instructions continued
Figure 25
Figure 28
1-800-295-5510
6. loosen screw with a 3mm Allen wrench and remove
the block through the window.
7. loosen screws with a 3mm Allen wrench and remove
the cap. (see Figure 27)
8. Remove the piston assembly with a 10mm spanner
wrench. (see FIgure 28)
9. Remove piston and replace.
Magazine Assembly
Piston Assembly
uline.com
Figure 26
spring
0514 IH-1030