Clinch Adjustment; Depth Adjustment - Uline H-1030 Mode D'emploi

clinch adjustMent

Use 2.5mm Allen wrench and turn collar through window
clockwise to tighten clinch. (see Figure 6)
Tight
Medium
Loose
Figure 6

depth adjustMent

1. loosen front screw with a 6mm Allen wrench.
(see Figure 7)
2. Push the body up and adjust to the desired depth.
(see Figure 8)
Figure 7
Adjustment Plate
Figure 9
PAGE 4 OF 20
safety instructions continued
3. When the top edge of the adjustment plate is at
its highest setting, the teeth are at their shallowest
penetration. (see Figure 9)
4. If set at no. 1 the teeth are at their deepest
penetration. (see Figure 10)
Figure 8
No. 1
No. 2 & 3
No. 4
Figure 10
Loosen
Tighten
0514 IH-1030