Preparing Water And Electrical Connections; Installing Moisture Barrier Tape - LG ADFD544 Série Manuel D'utilisation

result in kinked, pinched, crushed, stressed or
damaged lines.

Installing Moisture Barrier Tape

Install the moisture barrier tape to the underside
of the countertop to protect the surface from
condensation when the appliance is opened.
1
Clean and dry the area on the underside of
the countertop and the sides of the cabinet
opening where the tape will be applied.
2
Remove the protective film from the tape.
3
Install the tape on the underside of the
countertop.
4
Install the shorter pieces of tape on the sides
of the cabinet opening at the top.
NOTE
• Moisture barrier tape is included in the manual
assembly bag.
• If the countertop is made of granite or
waterproof materials, the moisture barrier tape
is not required.
• Condensation may occur on the underside or
along the front edge of the countertop when the
room temperature is low.
Preparing Water and
Electrical Connections
WARNING
• Water Connection
- Do not reuse an old hose. Use only a new hose
when installing the dishwasher. The old hose
could leak or burst causing flooding and
property damage. Contact an LG Customer
Information Center for assistance in buying a
new hose.
• Electrical Connection
- Use a time-delay fuse or circuit breaker.
- Operate this appliance with the correct voltage
as shown in this manual and on the rating
plate.
- The wiring must be grounded properly. If in
doubt, have it checked by a qualified
electrician.
- Connect the appliance using 3-wires, including
a ground wire.
- The appliance and outlet must be positioned
so that the plug is easily accessible.
- Do not use an extension cable or adapter with
this dishwasher.
- Do not overload the outlet with more than one
appliance.
- The included 16AWG wire nuts should be used.
- It is the personal responsibility and obligation
of the product owner to have a proper outlet
installed by a qualified electrician.
CAUTION
• When connecting the dishwasher water supply
line to the house water supply, sealing tape or
compound should be used on pipe threads to
avoid leaks. Tape or compound should not be
used on compression fittings.
• Connect the dishwasher to a hot water supply
with a temperature range between 120 °F (49 ℃)
and 149 °F (65 ℃). This temperature range
provides the best washing results and shortest
cycle time. To prevent damage to dishes, the
temperature should not exceed 149 °F (65 ℃).
INSTALLATION 11