Main Menu; Advanced Options - Ksenia ergo M Manuel Utilisateur

MAIN MENU

Partition status
EN
Zone status
Change PIN
ergo options

Advanced options

Fault list
Reset alarm
STOP calls
ADVANCED OPTIONS
Event logger
Enable maint.
Test event
Date and time manag.
Networking
Press Enter key to display the status (armed/disarmed) of
all partitions
Press Enter key to display the real time status (on/off) of
all zones and change their status (bypass/unbypass).
Press Enter key to change PIN code.
Press Enter key to modify the settings of the keypad you
are operating on: backlight, volume, the acoustic signal
when a 'Chime' zone is violate and touch sensitivity.
Press Enter key to gain access to the advanced functions.
Please, refer to the next table.
Press Enter key to display the detected faults; you can
browse through them using the circular scroll. Any
failure in the system memory will be erased showing
fault status.
Press Enter key to reset all the alarms.
Press Enter key to stop any actions of the telephone
dialer in consequence of an alarm (calls, SMS or e-mail).
Event logs display. Press Enter to display the records; you
can browse through the events starting from the last one
recorded. For additional details of the event, press the
Enter key again.
In this menu you can enable the installer to log in for
system maintenance. If this option is set to OFF, the
installer will have no access to the system for any
operation whatsoever.
Press Enter to generate the 'Periodic Test' event.
Date and time format settings
In this menu it is possible to verify the configuration
parameters: IP address / Subnet mask / Gateway.
22