Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Intended Use
This device is used for:
• The reception of radio programmes
• Playing audio CDs.
It is intended exclusively for this purpose and may only
be used as such. It may only be used in the manner
described in these instructions for use. The device must
not be used for commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to materi-
als or even personal injury.
The fi rm ETV – Elektro-Technische Vertriebsgesellschaft
mbH does not accept any liability for damage caused as a
result of the use of this device contrary to its intended use.
Start-up of the device/introduction
• Please read the operating instructions carefully
before using the device for the fi rst time!
• Select a suitable location for the device, such as
a dry, fl at, non-slip surface on which it is easy to
operate the machine.
• Ensure that the device is suffi ciently ventilated!
• Remove the protective fi lm from the display if it is
still present.
Power Supply
• Connect the power cable supplied (see battery com-
partment if necessary) to a properly installed 230 V /
50 Hz safety power socket and the mains connector
AC ~ (17) on the back of the machine.
• Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
Setting the Time (in Standby Mode)
1. Open the battery compartment (19) on the bottom.
2. Keep the SET button pressed down. Press the HOUR
button at the same time in order to set the hours.
3. In order to set the minutes, keep the SET button
pressed down and press the MINUTE button at the
same time.
4. Close the battery compartment.
NOTE:
The time is a 12 hour display.
AM = in the morning; PM = in the afternoon/evening.
Inserting the Batteries (not supplied)
• Open the battery compartment (19) on the bottom.
• Insert 6 batteries of type UM2/R14 1,5V. Please
ensure that the polarity is correct (see the inside of
the battery compartment)!
• If the device is not used for a long period of time,
remove the batteries to avoid the spilling of battery
acid.
05-SR 4320 CD AEG.indd 39
05-SR 4320 CD AEG.indd 39
• Close the battery compartment.
NOTE:
When a mains cable is connected the batteries are
automatically switched off .
CAUTION:
• Diff erent battery types or new and used batteries
must not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at
the relevant collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or
direct sunlight. Never throw batteries into the fi re.
There is a danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid
upwards by the tab (4).
• Before operating the machine for the fi rst time, re-
move the transport safety device from the CD player
if it is still in place.
Switch-off
The machine is switched off when the function selector
switch (16) is turned to the OFF position. Unplug the
device.
Volume
The desired volume can be sent using the VOLUME regu-
lator (15).
Listening to the Radio
1. Turn the function selector switch (16) to the RADIO
position.
2. Select the desired frequency band with the band
selection switch (20).
VHF (Stereo) = FM ST., VHF = FM,
Medium wave = AM (Mono)
3. Tune into the desired station using the TUNING
regulator (21).
4. The FM.ST control lamp only lights up when you have
selected FM stereo and the station is being received
in stereo quality. If reception is too weak and there
is noise on the station being received, this lamp
will fl icker. Where reception is bad we recommend
switching to FM.
5. For VHF/FM mode pull out the telescopic antenna (1)
and turn it to improve reception.
6. An aerial is integrated into the device for the recepti-
on of AM stations. The machine can be aligned to the
station by turning it. In this frequency band programs
are transmitted in „mono" only.
English
39
27.03.2008 9:03:13 Uhr
27.03.2008 9:03:13 Uhr
Publicité
Table des Matières
