Setting The Time And The Date - OERTLI AD223-RS 100 Notice D'utilisation

English
In normal operating mode, the display shows the time alternating with
the outside temperature (if an outside sensor is connected to the
boiler).
1

Setting the time and the date

Press the key using a pen and adjust the time and the day using
the + and - keys.
- Press once to make a minute by minute setting.
- Press again for hour by hour setting.
2 Description
1 Temperature setting keys
Comfort temperature
Reduced temperature
Domestic hot water temperature
2 Time and day adjustment key
3 Programming keys
4 Display
5 Setting keys + and -
6 Operating mode selection keys
- Key MODE: To select one of the following modes.
AUTOAutomatic mode
heating at comfort temperature until midnignt
heating at reduced temperature until midnight
Antifreeze mode. Set the required number of days (current day = 1) with keys + and - (up to 99 days). The switch is made at 0h.
Summer mode (heating OFF)
- Key : Switches domestic hot water on until midnight.
8
If the boiler is switched off, the display shows the time only, with
no other symbols.
- Press a third time for day by day setting by putting the arrow
the graphic bar from 1 to 7 (1 = Monday).
Keeping the + or - keys pressed speeds up the scrolling. A fine
setting can be made with short presses.
To set the time, the boiler must be switched on.
AD223 - RS 100
in
30/11/10 - 300010275-001-B