klover DIVA MID Mode D'emploi page 71

Scrape the flame trap and release any blocked holes.
It is also recommended to scrape the internal walls of the combustion chamber using a small spatula, to remove any deposits.
2
1
3
Remove and clean the two lateral flame trap supports and all of the upper part of the combustion chamber.
2
3
1
After having re-positioned the two lateral flame trap supports, also re-position the flame trap paying attention to insert the support tab inside the
flame trap slot.
ATTENTION: use suitable "bin" type suction devices, with fine mesh filter, in order to prevent part of the ash being spilled back out into the environment,
damage the suction device itself.
17