Publicité
Placement of Arm on the Wall
1. MOUNTING CONSIDERATIONS:
• Wall Mount Bracket MUST be attached to a stud or solid concrete. DO NOT attach this product to hollow wall or any other confi guration.
• Make sure Arm will have desired unobstructed range of motion: up-down, side-to-side, in-out (see section RANGE OF MOTION).
• Make sure cables will reach their destinations with enough remaining slack to allow Arm full range of motion.
• Use the RANGE OF MOTION section to familiarize yourself with the movements of this product. Take into account that the TV will change
location from Side-to-Side when pulled out from the wall.
• Use the SPACE REQUIREMENTS section for maximum measurements of this products full range of motion.
• If there is no available stud for desired TV location, you may want to insert horizontal studs into your wall at the desired mounting
location (see "Horizontal Studs" image below).
2. CHOOSE YOUR DESIRED TV LOCATIONS:
Choose your desired TV locations when stowed and extended. Note the TV will move side-to-side when pushing it into and pulling it
out from the wall as well as lifting it up and lowering it down. This step requires an understanding of this products Range of Motion (see
section RANGE OF MOTION).
RANGE OF MOTION
Front view with arm pushed back against the wall.
20.13"
(511mm)
SPACE REQUIREMENTS
Distance from the Wall
4 of 18
16.83"
(428mm)
20.4"
(518mm)
side
25.2" (640 mm) + Thickness
of TV
front
Horizontal Studs
1.38"
(35mm)
19.16"
(487mm)
10.63"
(270mm)
.98"
(25mm)
Horizontal Space Requirements
28.8" (640 mm) +
40.49" (1028 mm) + Width of TV*
Thickness of TV
*Space requirement dimensions assume mounting holes are centered on the TV.
top
front
Top view showing range of motion when pulled out from
the wall.
Vertical Space
Requirements
20.49" (520 mm) + Height
of TV*
front
888-45-255-W-01 revG • 05/15
top
If there is no available stud for
desired TV location, you may
want to insert horizontal studs
into your wall at the desired
mounting location.
Publicité
