Get Started; Charge Your Kids9Qcbt; Power On; Power Off - Sunstech KIDS9QCBT Mode D'emploi

User Manual
KIDS9QCBT

GET STARTED

Charge your KIDS9QCBT

Your battery has been partially charged at the factory, but you may need to recharge it before you can
switch the KIDS9QCBT on for the first time.
Make sure you use the original USB charger to charge your KIDS9QCBT or any charger totally compatible
(same connector, V and mA).
1. First connect the USB cable to the charger, and plug the charger into a wall outlet, and then connect the
micro-USB end of the cable to your KIDS9QCBT.
2. When the battery is full, disconnect the charger from the KIDS9QCBT, then from the wall outlet.
You don't need to charge the battery for a specific length of time, and you can use the KIDS9QCBT while it's
charging.
If the battery is completely discharged, it may need to charge for up to 20 minutes before you can use your
KIDS9QCBT. The charging indicator may not be displayed in this time.
First start up

Power On

Press and hold the POWER button during 5 sec approximately and the display will power on and show the
SUNSTECH logo.

Power Off

Press and hold the power key until the function off will appear, then select OK to confirm.

First installation

On the first POWER ON a easy step by step of configuration will appear. Only follow the
instructions that will appear in the display in order to complete the configuration of your new
device.
15 15
English