Care & Cleaning - Sage Super Q SBL920 Guide Rapide

Care & Cleaning
Vessels and lids
To avoid food drying on blades, vessels
and lids, follow the below steps as soon
as possible after use:
• Rinse most of the ingredients off the vessels
and lids.
2-litre jug
• Add 1L of warm water and 1–2 drops
of detergent and press the CLEAN button.
• Rinse the jug and lid again and/or wash
separately in warm soapy water with a soft cloth
or bottle brush.
Personal blender attachments
• All personal blender attachments are dishwasher
safe on top shelf.
• To help removing food residues from the blades
and cup walls you can add 250mL of cold water
to the personal blender cup and press CLEAN.
• Rinse the cup with warm water afterwards.
• If not clean yet, hand wash in warm, soapy
water using a mild liquid detergent and
non-abrasive sponge.
WARNING
There is a risk of pressurisation from
hot water and / or detergent. When rinsing the
personal blender cup by using the CLEAN cycle
never add hot or even warm water, as the steam
produced can create dangerous pressurisation.
Do not add detergent, as the foam produced will
expand and may cause pressurisation.
WARNING
Oils in citrus rind can damage the material of your
jug and personal blender cup if being exposed to
it for a longer period. Always clean your blender
jug and personal blender cup immediately after
processing citrus rind.
Motor base
To clean the motor base, wipe with a soft, damp
cloth then dry thoroughly. Wipe any excess food
particles from the power cord.
Cleaning agents
Do not use abrasive scouring pads or cleaners
on either the motor base or the jug, as they may
scratch the surface. Use only warm soapy water
with a soft cloth.
12
Dishwasher
The blender jug , personal blender cup, personal
blender blade system, tamper, scraper and all lids
can be washed in the dishwasher on a standard
wash cycle. Jug can be placed on the bottom shelf,
however the personal blender cup and lids should
be on the top shelf only.
Stubborn food stains and odours
Strong smelling foods such as garlic and fish, and
some vegetables such as carrots, may leave an
odour or stain.
2 Litre jug
To remove, clean the jug and lid using
the CLEAN instructions. Add 2 tablespoons
bicarbonate of soda and ½ cup (125mL) vinegar
into jug and let the mixture froth for 1 minute.
Scrub the jug and lid with the mixture using a soft
dishwashing brush. Add 2 cups warm water and
allow to stand for 5 minutes. Attach jug to blender
base. Secure lid and then press the CLEAN button.
Thoroughly rinse the jug, and allow to air dry. Store
jug and lid with the lid off to allow air to circulate.
Personal blender cup
To remove, pour warm soapy water and
fill to the MAX mark. Set aside to soak
for 5 minutes. Then wash with a mild detergent and
warm water, rinse well and dry thoroughly. Do not
use the CLEAN function to remove stubborn stains
and odours from your personal blender cup.
Dry milling
Milling hard ingredients like spices, nuts, sugar,
coffee, grains, etc will cause scratching and
clouding to the inside surfaces of the jug.
Some spices and herbs release aromatic oils that
may discolour the jug or leave an aroma.
These are cosmetic results from milling these
kinds of ingredients, and does not affect the
performance of the jug.
Storage
Store your blender upright with the blender jug
assembled on the motor base, or beside it. Store
the personal blender cup with the blade system
assembled. Do not place anything on top. To allow
air to circulate, keep the lid off.