Pioneer SGX-CA500 Mode D'emploi page 52

Sensor Settings
EN
Performing PowerMeter Calibration
PowerMeter calibration ensures that PowerMeter information
is received correctly.
• Refer to the PowerMeter Installation Manual for information
about mounting PowerMeter.
1
On the home screen, tap the [Sensors] icon.
2
Tap [Power] - [Calibration] - [Start Calibration].
This starts PowerMeter calibration.
3
Check the calibration result.
Calibration is complete when "Success" is shown in the
[Result] field.
• If "Failure" is shown, it means that calibration was not
performed correctly for some reason. Refer to the sensor
user's manuals.
52