Charging The Battery And Displaying The Charge Status - PEUGEOT Micro Mode D'emploi

EN
Folding the e-Kick
Fodling the e-Kick is just as simple as unfolding it :
1. Press the two blue buttons positioned at the top of the front part of the scooter in order to release the handlebars and refold
each handle.
2. Simultaniuosly press the two blue push knobs
3. Pivot the blue lever forward to release the hinge mechanism and fold the front part flat against the footboard until the tab at the
rear engages into the brakes pedal.
1 2
Strictly keep both hands on the positions shown on the illustrations at any time during folding and unfolding until the scooter is locked
in its position.
positioned at the bottom of the front part to release the blue lever.
3

Charging the battery and displaying the charge status

The charging process is described below :
1. Connect the charger to a power socket. The lamp on the charger should show a light green.
2. Now connect the e-Kick to the charger. You can see that the charger and scooter are connected correctly when the lamp on the
power supply unit changes to red (can take a few seconds). Also the LED lights on the e-Kick indicate the charging by
lightning two times in sequence.
3. When the e-Kick is fully charged, the display on the charger changes back to green.
In order to see the current charge status, switch on the scooter by turning the rear wheel. The same applies to checking the charge
status during the charging process.
1 2 3
12