UPPER BOUNCE UBRTG01-1017 Manuel D'utilisation page 8

FRAME ASSEMBLY FOR MODEL UBRTG01-1017
Step
1
Frame Layout
Lay out the trampoline parts on the ground
so that you start to form a rectangle with the
top rail sections. Make sure to keep all the
tubes in the same direction all around the
trampoline frame.
Step
2
Construct the Legs
Attach the leg extensions (part D), to the leg
base (part E), and tightly secure together
with screws (part J) and washers (part K).
Repeat this step for all 4 legs.
Step
3
Attach the Middle Support to the Legs.
Attach part P and part O. Once they are attached,
connnect the pole to the legs by sliding it on to the
leg extensions (part D). Slide the pole down the legs
until it stops. Repeat this step for all 4 legs.
Step
!
4
Assemble the Frame Corners
Lay out the trampoline parts as shown in the figure. Connect the corner rails (part C) to the
top rails (Part B) using screws and nuts (part I). Part C1 connects to part B1 and part C2
connects to part B2. Then attach to the leg bases as shown using screws and washers
(parts J & K).
Note:
Make sure that all
screw holes that
connect the B rails
to the legs are facing
the inside of the
frame.
8