Fixing The Appliance To The Wall - Electrolux EJF4842AOX Guide D'utilisation

Fixing the appliance to the wall

Note: This fixing part should be used for in the case of, the appliance is out off balance
when then the inside of the appliance is fully empty but the door shelves are full
with stuffs.
For usage please follow the below instructions
1- Check the kit to locate the following parts.
Part No Description
4 Screw M4 No:4
Screw f or plastic
3
No:3 (Ø 3,5mm)
2 Fixing Bracket
1 Screw grommet
2- Prepare a star-tip screwdriver for fixing the screws.
3- Prepare a driller for making hole to the wall.
4- Put the refrigerator, where you will use it.
5- Refer the holes, which has been drilled before on the top of the refrigerator, and
mark the hole places on the wall.
6- Drill the holes on the wall with Ø 6 mm.
7- Put screw grommet (Part no: 1) in to the hole.
8- Assemble the fixing part (no: 2) to the wall by using the plastic screw (part no:3)
9- W ith the screw M4 (Part no: 4) assemble the fixing bracket to the refrigerator.
10- If your appliance is Tropical class then fix Screw M4 to the "T" hole on the bracket;
if your appliance is Normal class the fix Screw M4 to the "N" hole on the bracket.
11- Do the same actions to the 2
Figure -1
Quantity
2 pcs
2 pcs
2 pcs
2 pcs
nd
fixing part.
2 1
4 HOLE
3
N F
T
For fixing Bracket (Part no: 2) to the appliance
For fixing Bracket (Part no: 2) to the w all
Main part f or f ixing
For fixing Plastic screw (Part no: 3) to the w all
Figure -2
N
T
ENGLISH
Used
F
17