Troubleshooting Guide - Di4 Jet Pressing 2850W Manuel D'utilisation

TROUBLESHOOTING GUIDE

Please consult troubleshooting table below for any issues you may face prior to contacting our sup-
port centre.
PROBLEM
UNIT FAILS TO HEAT UP AND
STEAM. POWER INDICATOR
LIGHT DOES NOT ILLUMINATE.
WATER RUNS OUT OF THE
HOLES IN THE SOLEPLATE.
WHITE STREAKS COME
THROUGH THE HOLES IN THE
SOLEPLATE.
BROWN STREAKS COME
THROUGH THE HOLES IN THE
SOLEPLATE AND STAIN THE
LINEN.
THE SOLEPLATE IS DIRTY
OR BROWN AND MAY STAIN
THE GARMENT .THE CLOTHE
STICKS IN THE SOLEPLATE
THERE IS NO STEAM OR
THERE IS LITTLE STEAM.
This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electri-
cal and electronic waste collection centre closest to your home.
20
POSSIBLE CAUSE
Unit is not plugged in.
Household Circuit Breaker
Water has condensed in the pipes
because you are using for the first
time or you have not used it for
some time.
The soleplate is not hot enough.
The boiler has a build-up of scale
because it has not been rinsed out
regularly.
You are using chemical descaling
agents or addititves in the water for
ironing.
You are ironing at too high a
temperature.
The water tank is empty.
The steam control dial is set at
minimum.
SOLUTION
Plug into electrical outlet.
Turn the knob on the
circuit breaker to the on
position.
Press the steam trigger
away from your ironing
board until the iron produces
steam.
Decrease the steam
output while ironing at low
temperature.
Rinse out the boiler.
Never add this type of
product in the water tank or
in the boiler.
Adjust the temperature dial
to a lower heat setting.
Fill the water tank.
Increase the steam output.