Functional Description - Makita LXLC01 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Take care not to trap finger(s) between cleaner and
•
battery as shown in diagram when loading battery.
Trapping finger(s) may cause injury.
011539
Installing or removing battery cartridge
3
011540
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the front of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Battery protection system
The cleaner is equipped with the protection system,
which automatically cuts off the output power for its long
service life.
The cleaner stops during operation when the cleaner
and/or battery are placed under the following situation.
1. Red part
1
2. Button
3. Battery cartridge
2
This is caused by the activation of protection system and
does not show the cleaner trouble.
When the cleaner is overloaded:
•
At this time, release the switch trigger and
remove causes of overload and then pull the
switch trigger again to restart.
When the remaining battery capacity gets low:
•
Recharge the battery cartridge.
Switch action
1
3
011542
To start the cleaner, simply press the "HIGH/LOW" button.
To switch off, press the "OFF" button. To change the
cleaner speed, press the "HIGH/LOW" button. The first
press on this button is for high speed and the second
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
Battery power lamp
1
3
011542
When the remaining battery capacity gets low, the
•
battery power lamp blinks.
When the remaining battery capacity gets much
•
lower, the tool stops during operation and the
battery power lamp lights up for about ten seconds.
At this time, remove the battery cartridge from the
tool and charge it .
NOTE:
The time at which the battery power lamp start
•
blinking or lighting up depends on the temperature
at work place and the battery cartridge conditions.
4
1. OFF button
2
2. HIGH/LOW
button
3. Battery power
lamp
1. OFF button
2
2. HIGH/LOW
button
3. Battery power
lamp