Installation - Klarstein VINSIDER 36 Manuel D'utilisation

EN
24

INSTALLATION

Before first use
Allow 24 hours before switching on the wine cooler. During this time we recommend that
you leave the door open to clear any residual odours.
Location
The location you have selected for your wine cooler should:
• be unencumbered and well ventilated;
• be well away from any heat source and direct sunlight;
• not be too damp (laundry, pantry, bathroom etc.);
• have a flat floor;
• have a standard and reliable electricity supply
• have a surge protector fitted to the electrical outlet;
• Away from the microwave oven. Certain microwave ovens do not have wave
interference shield. When placed within 1 meter vicinity of the wine cabinet, they
may affect the operation of the wine cabinet.
Placing in cold or hot temperature conditions may cause cooler's temperatures
fluctuating, and it will not reach the ideal one.
Installation
• Unpack and remove all of the protection and adhesive strips from the packaging
around and inside the wine cooler.
• The wine cooler must be positioned such that the plug is accessible. Release the
power cord. Move your wine cooler to its final location. The wine cooler should be
installed in a suitable place where the compressor will not be subject to physical
contact.
• Wine cooler must be levelled BEFORE loading your wines. Your wine cooler is
equipped with 4 adjustable feet to facilitate easy levelling. The cooler recommends
that you tighten the back feet to the maximum and adjust the front feet to level the
wine cooler.
Hints on built-in wine coolers
• Built-in wine coolers are front venting but are not designed to be fully integrated
behind a joinery door.
• Built-in wine coolers draw air from right of ventilation frame (some models from the
rear) and expel through left of ventilation frame under the front door.
• As with most appliances of today, the wine cooler has sensitive electronic
components which are susceptible to damage through lightning and electricity
supply faults. It is therefore advised to use a power surge protector to avoid
problems of this nature.
• Air vent on door must be provided for built-in wine coolers when a wood door
installed.