Shelves - Pando PVMAV 45-18 Manuel D'utilisation Et Installation

INOXPAN S.L.

5.3 SHELVES

To remove any of the shelves from the rail compartment, move the shelf to the position where
the notch of wooden shelf is exactly under the plastic post and then lift it up and out.
In order to replace the shelf, repeat steps described above in reverse. And make sure to engage
the shelves with the small pegs of the extended rails when the model is equipped with roller
system.
5.4 NOISE DURING OPERATION
This unit uses a compressor for cooling. The compressor pumps coolant through the cooling
system, which produces some operating noise. Even when the compressor stops, noises caused
by temperature and pressure changes are unavoidable. The operating noises will be more audible
just after switching off. The unit will be quieter when it has been working continuously for a time.
The following noises are normal and occur now and then:
• "Bubbling" noise caused by the coolant flowing through the coils of the appliance.
• Buzzing produced by the motor / compressor. This noise may be louder for brief periods when
the motor starts up.
• Clicks/ soft noises, resulting from contraction and expansion of the materials cause by
temperature differences.
• Fan noise, while circulating air inside the wine cabinet.
• Unusual noises are normally the result of incorrect installation. Under no circumstances
should the radiator tubes touch a wall, furniture or other tubes.
• If the unit is installed in an open-plan kitchen or in partition walls, operating noises could be
more audible. This, however will be due to the surrounding architecture and not the unit itself.
• Noise perception is directly linked to the surroundings of the unit, as well as the specific
model. Our appliances are in line with international standards and the latest technologies. But
please remember that noises produced by the compressor and the coolant are inevitable.
30
WINE CABINETS