IKEA HUTTRA Mode D'emploi page 8

ENGLISH
roast meat (beef, pork, lamb),
vegetables. Expiration dates on the
packaging of foods in the 2-star
zone must be respected.
To avoid food contamination,
please observe the following:
– Opening the door for long
periods can cause a significant
increase of the temperature in the
compartments of the appliance.
– Regularly clean surfaces that may
come into contact with food and
accessible drainage systems.
– Clean water tanks if they have
not been used for 48 h; flush
the water system connected to
a water supply if water has not
been drawn for 5 days.
– Store raw meat and fish in
suitable containers in the
refrigerator, so that it does not
come into contact with or drip
onto other food.
– Two-star frozen food
compartments are suitable for
storing pre-frozen food, storing or
making ice cream and ice cubes.
– Do not freeze fresh food in one,
two or three-star compartments.
– If the refrigerating appliance is
left empty for long periods, switch
off, defrost, clean, dry, and leave
the door open to prevent mould
developing inside the appliance.
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including
water supply (if any), electrical
connections and repairs must
be carried out by a qualified
technician. Do not repair or replace
any part of the appliance unless
specifically stated in the user
manual. Keep children away from
the installation site. After unpacking
the appliance, make sure that it
has not been damaged during
transport. In the event of problems,
contact the dealer or your
nearest Aftersales Service. Once
installed, packaging waste (plastic,
styrofoam parts etc.) must be stored
out of reach of children - risk of
suffocation. The appliance must
be disconnected from the power
supply before any installation
operation - risk of electric shock.
During installation, make sure the
appliance does not damage the
power cable - risk of fire or electric
shock. Only activate the appliance
when the installation has been
completed.
Be careful not to damage the
floors (e.g. parquet) when moving
the appliance. Install the appliance
on a floor or support strong enough
to take its weight and in a place
suitable for its size and use. Make
sure the appliance is not near
a heat source and that the four
8