Installing The Speakers; Cutting The Speaker Hole; Connecting The Speaker Wire - Bose Virtually Invisible 791 II Série Notice D'utilisation

Cutting the speaker hole

1. Trace the template in the speaker location.
WARNING: Do not cut into surfaces that have hazards
concealed behind them such as electrical
wiring or plumbing. If you are unsure of
your ability to mount this speaker, contact a
professional installer.
2. Drill a hole inside the template area large enough for your
cutting tool.
3.
Cut along the line you traced.
4. Remove the cutout section.
5. Clear away any torn or rough material from around
the hole.

Installing the Speakers

Connecting the speaker wire

1. Pull out at least 14 in. (36 cm) of the speaker wire.
Allow enough wire to connect the speaker from where you
are standing.
2.
Connect the positive wire to the red marked terminal on
the speaker.
Note: The terminal marking is located on the top of
the terminal.
Virtually Invisible 591 speaker
®
3.
Connect the negative wire to the black marked terminal on
the speaker.
Red (positive)
marking
English - 5