English; Safety Information - SpeedEPart Agri-Fab 45-04091 Mode D'emploi

ENGLISH

SAFETY INFORMATION

1. Read the information on the chemical package for
instructions and cautions on handling and applying.
2. Wear eye and hand protection when handling and when
applying lawn or garden chemicals.
3. Never allow children to operate the vehicle or spreader.
OPERATION
Do not use powdered lawn chemicals. They do not give a
satisfactory or consistent broadcast pattern.
1. Estimate the size of the area to be covered and calculate
the amount of material required.
2. Set the adjustable stop according to the flow setting
recommended in the application chart on this page.
Also refer to the instructions on the packaging for the
material to be spread.
3. Make sure the control lever is in the "OFF" position.
4. Fill the hopper, breaking up any lumpy fertilizer.
5. Start the spreader in motion and then pull the control
lever forward against the adjustable stop to the "ON"
position.
6. Always move the control lever to the "OFF" position
before turning or stopping.
7. To ensure uniform coverage, make each pass so that
the broadcast pattern slightly overlaps the pattern from
the previous pass. The approximate broadcast widths
for different materials are shown in the application chart
on this page.
8. For rectangular areas, make two passes across the
short ends to create turning areas. For non-rectangular
areas, make two passes around the entire border.
9. When broadcasting weed control fertilizers, make sure
the broadcast pattern does not hit evergreen trees,
flowers or shrubs.
STORING
1. Empty the spreader after each use, storing left over
material in its original bag.
2. Rinse the inside of the hopper and the exterior of the
spreader and dry off before storing.
3. Store in a clean, dry area.
APPLICATION CHART
TYPE MATERIAL
FERTILIZER
Granular
Pelleted
GRASS SEED
Fine
Coarse
ICE MELTER
TYPE MATERIAL
FERTILIZER
Granular
Pelleted
GRASS SEED
Fine
Coarse
ICE MELTER
IMPORTANT: Minor setting adjustments may be necessary
to compensate for humidity and moisture content of the
material.
CONTROL LEVER
ADJUSTABLE STOP
MAINTENANCE
1. Oil the free spinning wheel once a year or more often as
needed.
2. Oil the nylon bushings in the frame tube and the cross
brace once a year or more often as needed.
3. Apply a light coating of grease to the gears as needed.
4. Before each use make a thorough visual check of
the spreader for any bolts and nuts which may have
loosened. Retighten any loose bolts and nuts.
5. Make sure the tires are adequately inflated. Do not
inflate beyond the maximum pressure printed on the tire.
3
FLOW SETTING SPREAD
WIDTH
3 - 5 2,4 m - 3 m
3 - 5 3 m - 3,6 m
3 - 4 1,8 m - 2,1 m
4 - 5 2,4 m - 2,7 m
6 - 8 3 m - 3,6 m
FLOW SETTING SPREAD
WIDTH
3 - 5 8' - 10'
3 - 5 10' - 12'
3 - 4
4 - 5
6 - 8 10' - 12'
WING NUT
6' - 7'
8' - 9'